Zip Dry Paper Glue
COMMONLY USED SURFACE-TO-SURFACE APPLICATIONS
- Bonds paper to paper
- Bonds photos to paper
- Bonds small embellishments, beads, and glitter to paper
- Bonds wire to paper
- Bonds metal findings to paper
DIRECTIONS & TIPS FOR USING THIS PRODUCT:
Unscrew flat cap and remove seal. Keep cap.
Screw on precision tip applicator cap.
Remove white top and snip ¼-inch from tip for smallest opening.
Surfaces should be clean and free from dust.
Apply a thin bead of glue in from the edge of photos or other items to be bonded to avoid seepage.
Glue dries in about 5-10 minutes.
To store adhesive, allow glue to drain out of applicator cap into bottle. Replace applicator cap with flat cap and secure tightly.
SPECIAL TIPS:
Always test first for compatibility.
Glue dries rapidly, so apply one item at a time and keep covered between applications.
When not in use, store with flat cap.
To remove excess glue from applicator tip - insert Popsicle stick. Allow to dry. Pull out when done.
If seepage occurs, hold bonded item securely and rub off excess.
If glue thickens, thin with a few drops of paint thinner or turpentine.
5-10 minutes
CLEAN UP & REMOVAL RECOMMENDATIONS:
Rub off wet glue. Dried glue- use paint thinner or turpentine. Attempt to peel off non-porous surfaces.
CAUTION ADVISORIES OR SAFETY RECOMMENDATIONS:
Flammable in liquid state. Use in well-ventilated area.
