Home  >  Felted Crochet 'Hat' Accessories


Felted Crochet 'Hat' Accessories
enlargeenlarge

Felted Crochet 'Hat' Accessories

This jaunty little hat pin is a stylish accessory. Crochet in Patons® Classic Merino Wool, then felt it!.

For more information on how to felt, click the link to see how to Learn To Felt.

Designed by Patons® Design Studio

  
Project #:
e03861
  
 
 Crafting Time: 1 Hour
 Skill Level:
 1 being the easiest
 Crafters Rating:
  Review this project
  Add to My Michaels
  Printer friendly version
  Email to friend
 
  • Patons Classic Merino Wool, That's Red, 1 ball
    Note: 1 ball will make approx 12 Hats.
  • Size 5 mm (U.S. H or 8) Crochet Hook or size needed to obtain tension
  • Ribbon, 3 mm wide, Your Choice Color, 6-inches [15 cm] for hatband
  • Glue
  • Pin Backing for Lapel Pin
  • Keychain Hardware for Keychain
  • Stick Pin and Backing for Hat Pin
  • Small Clip for Purse Decoration

Cost of each project will vary depending on materials used.

Due to the seasonal nature of some merchandise, actual availability of some products pictured may vary.
 
     Important to know before felting:

 
     Record all the measurements and changes before and after felting. You will be able to adjust the method to produce proper results. Always test a sample. Different colored yarns may felt differently. Colorfastness can be affected by very hot water. Any knitting that has been properly felted becomes very dense and matted.
 
     To Make Hat
Ch3.
 
     1st rnd: 5 sc in 2nd ch from hook. Join with sl st to form a ring.
 
     2nd rnd: Ch 1. 2 sc in each sc around. Join with sl st to first sc.10 sc.
 
     3rd rnd: Ch 1. (1 sc in next sc. 2 sc in next sc) 5 times. Join with sl st to first sc. 15 sc.
 
     4th and 5th rnd: Ch 1. 1 sc in each sc around. Join with sl st to first sc.
 
     6th rnd: Ch 1. (1 sc in each of next 2 sc. 2 sc in next sc) 5 times. Join with sl st to first sc. 20 sc.
 
     7th rnd: Ch 1. (1 sc in each of next 3 sc. 2 sc in next sc) 5 times. Join with sl st to first sc. 25 sc.
 
     8th rnd: As 4th rnd. Fasten off.
 
     Finishing:
Felt Hat following How to Felt instructions. Shape Hat while wet and allow to dry away from heat and direct sunlight.
 
     Wrap ribbon around Hat for hatband as shown in picture and glue in position.
 
     Glue or sew pin backing to back of Hat brim for Lapel Pin.
 
     Sew keychain to edge of Hat brim for Keychain.
 
     Attach stick pin to back of Hat brim for Hat Pin.
 
     Sew clip to back of Hat brim for Purse Clip.
 
     If you like felting, here's more great project ideas:
Fabulous Felted Knit Flowers
Felted Knitting Needle Case
Tip:

Measurements:
Approx 2½-inches [6 cm] in diameter after felting.
Tension:
12 sc and 12 rows = 4-inches [10 cm].

Abbreviations:
Approx = Approximately
Ch = Chain
cm = Centimeters
g = Grams
in(s) = Inch(es)
mm = Millimeters
oz = Ounces
Rnd(s) = Round(s)
Sc = Single crochet
Sl st = Slip stitch.
 
The information on this instruction sheet is presented in good faith, but no warranty is given, nor results guaranteed. Quantities and selections may vary at each store. Michaels® Stores, Inc. disclaims all liability from any injury to anyone undertaking the construction of this project as a result of improper safety precautions. Since we have no control over physical conditions surrounding the application of information herein contained, MSI disclaims any liability for untoward results. © 2009 MSI.
  Add to My Michaels   Printer friendly version   Email to friend   Rate this project   More like this project