modern glam wedding: feather table number

Time Required :
15 minutes or less
Difficulty Level :
Beginner
Beginner
You're new to the skills necessary to complete this project, or maybe you've tried them just once or twice before.

Instructions Print

Step 1
On your computer, find a font and size you like, and design the table numbers. Print them out onto cream cardstock, leaving enough space around each number for the full size of the card.
Step 2
Trim down the cardstock around each number to the size you desire. 4" x' 6" is a good standard.
Step 3
Cut a piece of ribbon that will wrap around the base of the paper table number. Attach this with a tape runner.
Step 4
With the hot glue gun, glue a feather to the edge of the ribbon. Use the glue gun again to top it off with a button embellishment.
Step 5
Place each table card into its stand for display. To create your own stand, just cut out small triangles from the same cardstock, and glue the edge of each triangle to the back of one table number.
Step 6
Share your project photos with #MakeItWithMichaels 
 
 

Supplies Available Online

Supply List

  • Recollections® Cardstock Paper Value Pack, 8.5" x 11" (sku 10112997)
  • Surebonder® Mini Glue Sticks (sku 10203513)
  • Dress It Up® Craft Buttons, Fancy (sku 10279981)
  • ArtMinds™ Mini Glue Gun, Stylish Pattern (sku 10205222)
  • Celebrate It® 360°™ Double-Faced Satin Ribbon, 5/8" (sku 10387591)
  • Fiskars® Performance Titanium Softgrip® Scissors (sku 10189203)
  • Creatology™ Feathers (sku 10071418)
  • Recollections™ Adhesive Runner, Permanent (sku 10147423)
  • Recollections™ Signature Paper Trimmer (sku 10202471)
  • Computer
  • Printer
 
+ View More

Instructions

Step 1
On your computer, find a font and size you like, and design the table numbers. Print them out onto cream cardstock, leaving enough space around each number for the full size of the card.
Step 2
Trim down the cardstock around each number to the size you desire. 4" x' 6" is a good standard.
Step 3
Cut a piece of ribbon that will wrap around the base of the paper table number. Attach this with a tape runner.
Step 4
With the hot glue gun, glue a feather to the edge of the ribbon. Use the glue gun again to top it off with a button embellishment.
Step 5
Place each table card into its stand for display. To create your own stand, just cut out small triangles from the same cardstock, and glue the edge of each triangle to the back of one table number.
Step 6
Share your project photos with #MakeItWithMichaels