Photo Charm Necklace
Material List
- Necklace Bezel
- Photo
- Craft Glue – White
- Adhesive Rhinestones
- EnviroTex® Jewelry Resin Kit
- Drinking Straw (or Small Heat Gun)
- Waxed Paper
- Ribbon
- Ribbon Crimp Clamps
- Jump Rings
- Clasp
Project Instructions
Trim picture to fit bezel.
Glue picture into place with white craft glue and let dry.
Coat top of picture with two layers of white craft glue and let each layer dry.
Decorate the picture surface with the adhesive rhinestones.
Cover work space with a piece of waxed paper.
Mix a small amount of EnviroTex® Jewelry Resin per kit instructions.
Pour a little resin onto bezel and spread with a stir stick. Add more resin until it forms a slight dome.
After about 25 minutes, gently blow through a straw over any remaining bubbles on the resin surface. Leave in place to dry for 24 hours.
Cut ribbon to desired length and attach a ribbon crimp clamp to each end.
Attach jump rings to clamps and attach clasp.
Tips
The bezel must lay flat on the tabletop when filling it with the jewelry resin. If the loop does not allow the bezel to lie flat then raise it up by putting it on top of a small bottle cap.
