Laser HEAT TRANSFER PAPER Light Techni Print EZP 25 Sheets 8.5”x11” Made in USA


TECHNI-PRINT® Papers are designed for both oil and oil-less laser printers and copiers. They are for the heat transfer of photos and images to T-shirts, sweatshirts, mousepads,coasters,puzzles,handbags,binders,pad folios,paper,leather,magnets,wood veneer, nylon and more. Choose garments that have a tight weave. This is particularly important when transferring to sweatshirts.


PRINTING


For printing onto textiles (ie: Shirts, mouse pads, etc) Set your resolution to 200-250 DPI maximum. Printing at higher resolutions than this is a waste. Fabric can only hold approximately 200-250 DPI of resolution! You will still get good photo quality results.


1. Mirror the image.

2. Load the paper so that the image will appear on the coated side of the paper.


Fan the sheets of transfer paper on all four sides to reduce static charge Place the paper in by-pass tray (if available)


3. TECHNI-PRINT® Paper should be fed into the copier or printer with the short dimension first (grain long).


4. Start with “Plain Paper” mode. If toner does not fuse completely, adjust to a heavier paper setting.


5. Trim away the unprinted areas of the transfer for softer hand (feel) if desired.


TRANSFERRING Using a Commercial Heat Press (only)


1. Place the transfer sheet face down on the substrate and press:


30 seconds at 375oF using heavy pressure. Press must snap closed firmly.


2. Peel while still hot! Peel Transfer IMMEDIATELY.


WASHING INSTRUCTIONS


Turn garment inside out and wash in cold water using a mild detergent. Do not use bleach. Dry on low heat setting. Do not iron directly on the transferred area.


STORAGE AND HANDLING OF TECHNI-PRINT EZP HEAT TRANSFER PAPERS


Store TECHNI-PRINT® 4.0 Papers in a cool, dry area and do not remove from carton or poly bag until you are ready to use.