Red and Silver Mesh Wreath
Add to Favorites Print

Red and Silver Mesh Wreath

You can create as many loops as you want on your wreath. Tight loops create a smaller wreath, loose loops create a larger wreath. Play around with which look you prefer.
Craft Time: 60+ minutes
Uses Recycled Items: No
Get exclusive offers about this product and more!

Material List

  • Celebrate It« Occasions™ Mesh, 6" - Silver and Red
  • Wire Wreath Form, 18"
  • Celebrate It® Ribbon - Silver Sheer/Glitter Striped and Red/Silver Stripe
  • Creatology™ Chenille Stems - Silver
  • Scissors

Project Instructions

Step 1:
Cut chenille stems in half.

Step 2:
Gather end of silver mesh while still on the roll and another section approximately 4"-6" from end. Pull gathered sections together and tie onto wreath form. For a more full wreath, begin with the inside ring of the wire wreath.

Step 3:
Gather another section approximately 4"-6" from the last and tie onto wire wreath form.

Step 4:
Continue this until the inside ring is covered and then repeat for the outside ring.

Step 5:
Tie end of red mesh with a chenille stem to the outside ring where bow will be.

Step 6:
Loop red mesh within the silver mesh on the outside ring as shown. Use chenille stems to secure.

Step 7:
Make a multi-loop bow with both ribbons and secure center with a chenille stem. Tie onto wire wreath with the chenille stem. Tuck or trim excess chenille stems and / or ribbon.