Red and Silver Mesh Wreath
- Celebrate It« Occasions™ Mesh, 6" - Silver and Red
- Wire Wreath Form, 18"
- Celebrate It® Ribbon - Silver Sheer/Glitter Striped and Red/Silver Stripe
- Creatology™ Chenille Stems - Silver
Cut chenille stems in half.
Gather end of silver mesh while still on the roll and another section approximately 4"-6" from end. Pull gathered sections together and tie onto wreath form. For a more full wreath, begin with the inside ring of the wire wreath.
Gather another section approximately 4"-6" from the last and tie onto wire wreath form.
Continue this until the inside ring is covered and then repeat for the outside ring.
Tie end of red mesh with a chenille stem to the outside ring where bow will be.
Loop red mesh within the silver mesh on the outside ring as shown. Use chenille stems to secure.
Make a multi-loop bow with both ribbons and secure center with a chenille stem. Tie onto wire wreath with the chenille stem. Tuck or trim excess chenille stems and / or ribbon.