Sparkling Fence Bracelet
- Acrylic Studded Sliders – Silver (4)
- AB Faceted Lentils – Amethyst (4)
- Crimp Ends – Silver (2)
- Jump Rings, 20 ga. 3.5mm (7)
- Crimp Tubes, 2x2mm (8)
- Flexible Beading Wire, 0.018 (3')
- Toggle Clasp
- Leather Cord, ¼" (12")
- Sharp Scissors
- Chain Nose Pliers
Cut two 6" pieces of deep green leather cord. Line up one set of ends and use chain nose pliers to attach a crimp end to both pieces so there is a slight gap between the pieces of cord. Repeat on the opposite ends.
Cut twelve 3" pieces of .018 beading wire. Slide a lentil to the center of a 3" piece of wire. Position the bead on the outside of the cord, pull the ends across the inside, and pass both ends through a crimp tube going in opposite directions. Pull the tension snug, but not tight, and use chain nose pliers to flatten the crimp tube on the inside of the cords.
Next, attach a studded silver slider, using one piece of flexible wire and one crimp tube for each of the two holes in the slider.
Continue adding lentils and sliders in an alternating pattern until there are four of each on the cords.
On one end, attach two jump rings to the crimp end, attaching the loop half of a toggle clasp to the second jump ring. On the opposite end, attach five jump rings, adding the bar half of the toggle with the fifth jump ring.
Finished Size: 7¼"