Thanksgiving Card Centerpiece
Everyone will be talking about this unique Thanksgiving centerpiece you created!
Designed by Linda Colllette courtesy of me & my BIG ideas®
- 12” x 12” mambiKIT™ by me & my BIG ideas®
- Perfect Pumpkin soft spoken™ by me & my BIG ideas®
- Give Thanks Pilgrim soft spoken™ by me & my BIG ideas®
- Brown cardstock
- Adhesives, scissors and paper trimmer
Trim brown cardstock 12” x 8” then score every 2” both horizontally and vertically. You will end up with six 2” squares horizontally and four 2” squares vertically.
Using a paper trimmer or straight edge, slice on the three centered horizontal scores after the first 2” square and ending on the fifth 2” square. You will have horizontal center cuts with four 2” squares each leaving a vertical edge at front and back.
On the cut horizontals alternate your folds on the first and last squares, leaving the center two squares unfolded. If you struggle with the folds look closely at the image.
Trim green hounds tooth paper from kit 7 ¾” x 3 ¾”, hold against front vertical panel of card, mark your cuts to allow 1/8” brown cardstock border, trim and adhere to panel. Trim same paper 7 ¾” x 1 ¾” and adhere to back vertical panel.
Trim two pieces of brown November paper 7 ¾” x 1 ¾” and adhere to first and third horizontal centered panels.
Trim orange stripe paper 5 ¾” x 1 ¾” and adhere to second horizontal panel.
Trim orange dot paper 5 ¾” x 1 ¾” and adhere to bottom horizontal panel.
Reinforce folds again with new papers.
Add “HAPPY Thanksgiving” and brown rhinestone embellishments to front vertical panel as shown.
Add “give Thanks” and “Family Traditions” to back vertical panel.
Add additional soft spoken™ embellishments and rhinestones as shown.