Cedar Lodge Winter Antler Mount Lights
Add to Favorites Print

Cedar Lodge Winter Antler Mount Lights

Create these wonderfully unique lights for mounting on your wall.

Designed by Margaret Pankhurst.

Uses Recycled Items: No
Get exclusive offers about this product and more!

Material List

  • Wood Plaque (2)
  • Styrofoam® Ball, 6" (Cut in Half)
  • Decorative Scrapbook Paper – White
  • LED Lighted Branches
  • Nails (2)
  • Hammer
  • Drill
  • Drill Bit, ½"
  • Skill Saw
  • Acrylic Paint – White
  • Paintbrush
  • Wood Glue
  • Spray Adhesive
  • Fuzzy Fabric – White
  • X-ACTO® Knife Blade
  • Pencil
  • Jewelry – U-pins
  • Scissors
  • AA Batteries

Project Instructions

Step 1 Paint the edges of the plaques with white acrylic paint.

Step 2 Spray adhesive to the top of one of the plaques and adhere the decorative scrapbook paper.

Step 3 Trim with the X-ACTO® knife blade to match the silhouette of the wood plaque.

Step 4 Draw a 5"x5" square on the back of the other plaque.

Step 5 Drill a hole through the plaque in the center of the drawn square (see photo).

Step 6 Put the skill saw through the drilled hole and cut out the 5"x6" drawn square.

Step 7 Use wood glue to glue the two wood plaques together back to back. Allow to dry.

Step 8 Cut the Styrofoam® ball in half.

Step 9 Trim to the shape of half of an animal head using a long X-ACTO® knife blade.

Step 10 Cut two long holes on either side of the Styrofoam® ball for the antler placement.

Step 11 Form the fabric over the Styrofoam® shape and hold the fabric in place with the U-pins.

Step 12 Place the covered foam ball onto the covered wood plaque side and mark the placement of the antlers.

Step 13 Drill a ½" hole through the plaque for each antler (see photos).

Step 14 Carefully feed the lighted branches through the back of the wood plaque and secure the ends with a nail into the side of the plaque (see photos).

Step 15 Fit the carved and fabric covered Styrofoam® shape around the lighted branches and hot glue in place.

Step 16 VELCRO® the battery box to the inside of the plaque hole.