
happy halloween ribbon wreath
Step 1 |
Pre-cut around 25 black chenille pipe cleaners in half and set aside. |
Step 2 |
Twist a chenille pipe cleaner around the end of the black and white stripe ribbon mesh and attach it to the middle section of the wire form. Make a puff with the mesh, add another chenille pipe cleaner after the puff and attach it to the middle section of the wire form. Continue to bunch, poof and attach the mesh to the wire form working around the wreath form until the roll is gone. |
Step 3 |
Cut 10” [25.4 cm] of the ribbons you want to use on your wreath. |
Step 4 |
Fold the ribbons in half lengthwise. Cutting upwards toward the outer edges at an angle, this will make the V-shape end. |
Step 5 |
Layer the ribbons and twist together with a chenille pipe cleaner. |
Step 6 |
Place the layered ribbons in between the ribbon mesh and twist tight to the wire form. Repeat until the wreath is full. |
Step 7 |
Using floral wire, secure the wooden plaque to the middle of the wreath. Twist the floral wire around the wreath form. |
- Ruler
- 1 - 9.5" Black & White Mesh Halloween Ribbon by Celebrate It™ (10664025)
- 1 - 2.5" Orange Burlap Halloween Ribbon by Celebrate It™ (10664076)
- 1 - 2.5" Marble Halloween Ribbon by Celebrate It™ (10664078)
- 1 - 2.5" Orange & Navy Plaid Halloween Ribbon by Celebrate It™ (10664085)
- 1 - 1.5" Web Foil Halloween Ribbon by Celebrate It™ (10664091)
- 1 - 2.5" Black Mesh Halloween Ribbon by Celebrate It™ (10664092)
Step 1 |
Pre-cut around 25 black chenille pipe cleaners in half and set aside. |
Step 2 |
Twist a chenille pipe cleaner around the end of the black and white stripe ribbon mesh and attach it to the middle section of the wire form. Make a puff with the mesh, add another chenille pipe cleaner after the puff and attach it to the middle section of the wire form. Continue to bunch, poof and attach the mesh to the wire form working around the wreath form until the roll is gone. |
Step 3 |
Cut 10” [25.4 cm] of the ribbons you want to use on your wreath. |
Step 4 |
Fold the ribbons in half lengthwise. Cutting upwards toward the outer edges at an angle, this will make the V-shape end. |
Step 5 |
Layer the ribbons and twist together with a chenille pipe cleaner. |
Step 6 |
Place the layered ribbons in between the ribbon mesh and twist tight to the wire form. Repeat until the wreath is full. |
Step 7 |
Using floral wire, secure the wooden plaque to the middle of the wreath. Twist the floral wire around the wreath form. |