Preheat the iron to the polyester setting.

- Lay the shirt flat on an ironing board (or on a towel on a hard surface such as a counter top). Remove the sticker from the shirt.

- Fold the shirt in half vertically. Measure down 2" from the bottom of the neckline seam and make a light dot with the pencil.

#@#

- Cut out one B and two Fs. Cut the letter out of the sheet first and then trim closely around the letter.

- Hold one of the F’s up so you can see the letter through the backing. Measure and mark the middle of the letter with the pen.

#@#

- Iron the area where the letters will go to warm up the area. Lay down the marked F and center it on your pencil mark. Line up the top of the letter on the mark as well. The plastic side will face up (fuzzy side goes against the shirt). Make sure the letter is not upside down.

- Lay the pressing cloth on top of the letter and iron on it for 60 seconds, continuously moving the iron over the letter. Open the shirt up and/or inside out and iron on the shirt and letter for 20 seconds.

#@#

- Turn the shirt right side out and carefully peel the plastic backing off. Lay the ruler across the bottom of the iron-on F and measure ½" from the edge to the outermost edge of the B. Repeat Steps 5-7 for this letter.

- Repeat for the second F.

NOTE: The letters in the image are measured ½” apart. You may alter this measurement as desired, but remember to do the same measurement between letters.

#@#

- When the letters are ironed on, iron the rest of the shirt, avoiding the letters, and fold neatly.

- Share your project photos with #MadeWithMichaels

Neon BFF T-Shirt

Instructions

ADDITIONAL MATERIALS