First, click here for the design in Cricut® Design Space™.
TIP: The design is broken up into four separate spider webs grouped together to make one design. This makes it easier to attach to any tumbler. Measure the circumference around the top edge of your tumbler, size the design as needed; then slightly overlap each side across the top so it appears to be one long spider web.

#@#

Now, click ‘Make It’ in the upper right corner and then click ‘Continue’ in the lower right corner of your screen.

#@#

Place your vinyl, grid-side down, onto your cutting mat and load it into your Cricut® machine. Select ‘Vinyl’ as your material and follow the prompts to cut out your design. Once the machine has finished cutting, gently peel the vinyl away from your mat.

#@#

Use scissors to cut away the vinyl around your design. Next, use your weeder tool to peel away the remaining negative space surrounding and within your spider webs. When you’re done, only the design itself should be left on the backer paper.

#@#

Cut a piece of transfer tape that’s just a bit larger than your first spider web design. Peel away the tape’s backer paper and place the tape, sticky-side down, over this part of the design. Burnish the vinyl so that it’s completely stuck to the tape.
TIP: Clean the outside of your tumbler with rubbing alcohol to remove any dirt and/or oils.

#@#

Now, gently peel the white backer paper from the cut-out design, which now should be stuck to the transfer tape.

#@#

Hold the transfer tape with the design over your surface to determine where you’d like it placed; then press it onto your surface. Burnish the vinyl once more to make sure it’s completely stuck to the surface and gently peel away the transfer tape, leaving the vinyl transferred to your surface.

#@#

Repeat Steps 5-7 for each remaining spider web around your tumbler.

Share your project photos with #MakeItWithMichaels

Spider Web Tumbler

Instructions

ADDITIONAL MATERIALS