Druid from Bite the Bullet's Bullet Hell: Heroes set. Physical printed resin miniature with base Base apx 25mm across Body apx. 38mm from Right foot to eye Total height apx. 59mm --- Unassembled: This particular model consists of 2 separate pieces (base, body) - super glue or a like adhesive will be needed to put it together. Assembled: Figure and base will be securely resin-welded together Assembled + Primed: Figure will be assembled, then air primed with Vallejo surface primer in neutral grey --- Printed in Syratech Grey for crisp, clean details I do my best, but some light sanding, gap filling or other cleanup prior to painting may be required. Please note the listing image is the artist's render. I can't actually print in solid color. 99% of the time your figure will be navy grey, unless I run out and must use a different resin. Minis printed on demand, please allow a little time to make and clean them. I am officially licensed to sell physical prints of models designed by Bite the Bullet. __ About scale: Miniature scale can vary between different sculptors and miniature lines, and different people have different ideas on how scaling works. That being said, if a scale is listed, it was set by the sculptor, and not something I determined. So that nobody is surprised, I measure each and every model from foot to center eye (or eyes. or where the eye probably is.) and put those numbers right up top so you can easily see if a model fits your table