This listing is for 1 diy Direct to Film Transfer ONLY. Preview images shown are for reference only. (heat press required) Pressing Instructions: Heat press is SUGGESTED for these transfers. Cricut press or hand iron may not lead to high quality press. Basic Instructions: 1. Set heat press to 300-325 depending on your press. Start with a lower temp and increase if needed. 2. Pre-Press the material for 5 seconds to remove moisture. 3. Place your DTF transfer image side down into position on your material. 4. Heat press transfer for 15 seconds with medium to firm pressure. 5. Remove the material from the heat press with the transfer still attached and set aside until completely cooled. 6. After cooled completely, slowly remove film and repress for 10 seconds (with parchment paper to protect the design). * If the transfer is not fully adhered then please repeat step 4. Washing Care Guide: Wait 24 hours before first washing. Turn the garment inside out. Machine wash with mild detergent. NO bleach. Dry at a normal low dryer setting on household machines or hang dry. Do not dry clean. Do not use fabric softener. Notes: • Textures such a glitters, foil, watercolor, wood, animal prints, etc... are part of the design and are printed on the product - they are not real! Unless you purchase a specialty film transfer. • Colors may vary from online to your actual printed product. The printing process and your viewing screen can greatly affect how colors appear online vs printed.