Bookmark is 5in

This set comes as a mirrored set.

Please see photos for size reference.

These sharp and sturdy polymer clay cutters effortlessly slice through clay, ensuring clean, precise shapes with every use.

Cutters are 3D printed with biodegradable PLA, this product is environmentally friendly and will last for years if used, cleaned, and stored properly. PLA colors may vary based on what I have in stock at time of printing.

This is a physical product, not a STL file.

CUTTER SIZE
• Cutters are measured from the length of the longest edge.
• Cutter height is .5in / 1.5cm / 11mm
• Cutting edges vary between .2-.4mm

HOW TO USE
• Roll clay slab on a glossy, flat surface such as a glass or ceramic tile.
• Highly suggest using cornstarch over soapy water (soapy water breaks down PLA material)
• Use "double press" method to get a clean cut and avoid clay sticking in cutter
• Tap into cornstarch, press half way into clay and release. Tap into cornstarch a second time, press all the way through clay, wiggle slightly if needed and release.
• Dust off excess cornstarch with soft bristle brush such as a blush brush.
• Bake per clay instructions {I personally bake at 275 degrees for 45-60minutes for a strong finished product}

CUTTER CARE
• Hand-wash gently with cool water. DO NOT SOAK!
• Store in a cool dry place
• Do not expose to heat or direct sunlight
• NOT dishwasher, microwave or oven safe!!

I invite you to visit my Instagram @prismclayco for my daily updates, tips and tricks. Also, don't forget to tag me in your creations so I can reshare!

BOOKMARK | RECTANGLE | CLAY CUTTER

BOOKMARK | RECTANGLE | CLAY CUTTER